Front landing gear problems.

Question

2005 Keystone Copper Canyon Sprinter-Front landing gear on the drive side had the square insert in the jack assy,which has the drive shaft run through it back out. Allowing the drive shaft to wobble to much. Also found what looked like a spacer pinched between the top gear and worm gear.Hard to explain but would anybody know where to find a parts breakdown on the landing gear? Thanks Rich

donn0128 · Answer

If you have a Venture Mfg landing gear, it is available online.  To check mfg, pop the top cap off of one of the legs and look.  On the underside will be a model and serial number.

old-biscuit · Answer

Venture Landing Gear parts/drawings

george_h · Answer

Our 2005 Carriage has an Ultra Fab landing gear, Ultra Fab was great to work with when I damaged jack. Identification is etched into upper housing and filled with paint on 5er, had to trace etching in order to read.

rallison · Answer

It is a Fulton landing gear.

Forum Discussion

Front landing gear problems.

4 Replies

About Fifth Wheel Group

Related Content

Front Landing Gear

Front landing legs wont work - advice

Landing gear problems

Front Landing Leg Problem

Front Landing Jacks Speed