Getting ready and found this!
I endlessly prepare to leave on a big trip--and occasionally actually do go. So yesterday I started thinking about checking my suspension and slid under the rear axle--just for a look. I was startled ...
Forum Discussion
WNYBob wrote:
Wantabe351 is right
Mor-Ryde
Those hangers are to wide front to back for the X-Factor crossmembers to saddle around. Just have a welding shop weld on square tubes side to side and all three hanger locations. Lippert has sheet on doing it.
Page two of this has Lippert's instructions.
https://www-odi.nhtsa.dot.gov/acms/cs/jaxrs/download/doc/ACM18731969/RCRIT-11V486-1111.pdf
