Light fixture

Had a 07 Elite. I suspect you have the same 18" that I had. Yes you are doing the correct thing....they were hard to remove. I used to work on one side only till it was all off. The biggest problem I had was that the fixture itself would die....the tubes were OK. I replaced quite a few fixtures (ordered from DRV) before converting them to LED.

Assuming you are referring to this type of light fixture...


The lens should slide AWAY from the center switch about 3/8" to 1/2" and then drop down and away from the fixture.

I just squeeze in on the lens and slide away from the center of the light fixture and it falls into my hand... There is also a small clip on the top of the lens you may have to push in on at the same time you squeeze the two sides..

You can almost see the four slots the lens uses to hold itself inplace inthe above photo...

Once you do it you will see how easy they comes off...

Roy Ken

Pinch and wrestle with it.

Sometimes I win first match.....sometimes it takes a couple of bouts.

And your other post is under 'Ceiling Light'

If looking for one of your post......
When you log on.....click on 'My Forums' (top right just under your log in name)
Then click on 'My Posts' (it will then go to all your posts)