Montana high country 338DB needs more batteries

Yes, I had seen those at their site and I probably should have mentioned them (sold as Commercial quality). But MSRP is over $110 (Amazon is under $90)! Looks like really good quality stuff but . . .

GoPackGo wrote:
You could do that. I looked at the MTS web site. They make the individual vent components, so you could add another outside vent (one for each 6-volt battery). But they do not apparently make the part that the vent hose would attach to on top of the battery. Perhaps you could make up something out of PVC from Home Depot. And if you could figure a way to join 2 vent hoses into a Y configuration, you could use your existing single vent on the outside of your fiver, otherwise you'd need to add another vent outlet.

I believe NOCO makes a box that will hold both 6V batteries in one box. Then I would just use my existing vent and drill a hole in the top and do like you say with some PVC or something to attach it. I think this might be the route I go.

You could do that. I looked at the MTS web site. They make the individual vent components, so you could add another outside vent (one for each 6-volt battery). But they do not apparently make the part that the vent hose would attach to on top of the battery. Perhaps you could make up something out of PVC from Home Depot. And if you could figure a way to join 2 vent hoses into a Y configuration, you could use your existing single vent on the outside of your fiver, otherwise you'd need to add another vent outlet.

GoPackGo wrote:
I used the NOCO HM306BK models ON MY BOAT. They have small vents on the top. Cables are routed through any of those squarish protrusions you see built in to the corners of the caps. These also act as vents. So there is lots of venting - just not directly to the outside. They are good, heavy duty boxes.

My fiver came with boxes that look like the ones in your last link (has vent hoses attached).

I am not qualified to give anything more then an opinion. I don't know the volume of gases given off so I don't know how crucial it is to have direct outside venting. I do know that you want some kind of venting.

My fiver has the battery boxes in the front compartment with vent hoses leading to vents that face outward on the front. The batteries give off nasty fumes when being recharged so you do want some kind of vent arrangement. The compartment on my rig also can double as the genny compartment and because of that has cutouts in the bottom that allow air circulation as well as for an exhaust hose exit. Because of this, I would not worry if the boxes were not directly vented.

IMHO, you do not want boxes that have open drains in the bottom. Any liquid going out that drain will be acidic. I don't want something like that exiting out the bottom and being spread all over the bottom of my trailer. I want boxes with sealed bottoms.

I kind of agree with you, if I had a leak I wouldn't want that spraying all over the underside of my fifth wheel, that would make a mess. I think maybe I should order one of those boxes and maybe, but maybe not cut in the outside vent in to the lid of it?

I used the NOCO HM306BK models ON MY BOAT. They have small vents on the top. Cables are routed through any of those squarish protrusions you see built in to the corners of the caps. These also act as vents. So there is lots of venting - just not directly to the outside. They are good, heavy duty boxes.

My fiver came with boxes that look like the ones in your last link (has vent hoses attached).

I am not qualified to give anything more then an opinion. I don't know the volume of gases given off so I don't know how crucial it is to have direct outside venting. I do know that you want some kind of venting.

My fiver has the battery boxes in the front compartment with vent hoses leading to vents that face outward on the front. The batteries give off nasty fumes when being recharged so you do want some kind of vent arrangement. The compartment on my rig also can double as the genny compartment and because of that has cutouts in the bottom that allow air circulation as well as for an exhaust hose exit. Because of this, I would not worry if the boxes were not directly vented.

IMHO, you do not want boxes that have open drains in the bottom. Any liquid going out that drain will be acidic. I don't want something like that exiting out the bottom and being spread all over the bottom of my trailer. I want boxes with sealed bottoms.

dedmiston wrote:

JCasper wrote:

GoPackGo wrote:
Why not use 2 ea 6-volt marine boxes ? West Marine will have them. Or Amazon.

Like this?
http://www.amazon.com/NOCO-HM306BK-Snap-Top-Automotive-Batteries/dp/B00316KU6E

or like this?

http://www.amazon.com/NOCO-HM426-Commercial-Automotive-Batteries/dp/B003VAUG5A/ref=sr_1_1?ie=UTF8&qid=1457464801&sr=8-1&keywords=dual+6v+battery+box

These don't vent/drain out the bottom or have a line running outside like these RV ones do. Does it matter? This is what was in my fifth wheel from the factory.

http://www.amazon.com/MTS-Company-200275-Vented-Battery/dp/B00KPR877G/ref=sr_1_2?ie=UTF8&qid=1457465287&sr=8-2&keywords=rv+vented+battery+box

That first link looks like something you could store your cat in.

I like the vent though. Can you daisy chain those together if you have more than one?

I don't know about using one vent for multiple batteries.

JCasper wrote:

GoPackGo wrote:
Why not use 2 ea 6-volt marine boxes ? West Marine will have them. Or Amazon.

Like this?
http://www.amazon.com/NOCO-HM306BK-Snap-Top-Automotive-Batteries/dp/B00316KU6E

or like this?

http://www.amazon.com/NOCO-HM426-Commercial-Automotive-Batteries/dp/B003VAUG5A/ref=sr_1_1?ie=UTF8&qid=1457464801&sr=8-1&keywords=dual+6v+battery+box

These don't vent/drain out the bottom or have a line running outside like these RV ones do. Does it matter? This is what was in my fifth wheel from the factory.

http://www.amazon.com/MTS-Company-200275-Vented-Battery/dp/B00KPR877G/ref=sr_1_2?ie=UTF8&qid=1457465287&sr=8-2&keywords=rv+vented+battery+box

That first link looks like something you could store your cat in.

I like the vent though. Can you daisy chain those together if you have more than one?

GoPackGo wrote:
Why not use 2 ea 6-volt marine boxes ? West Marine will have them. Or Amazon.

Like this?
http://www.amazon.com/NOCO-HM306BK-Snap-Top-Automotive-Batteries/dp/B00316KU6E

or like this?

http://www.amazon.com/NOCO-HM426-Commercial-Automotive-Batteries/dp/B003VAUG5A/ref=sr_1_1?ie=UTF8&qid=1457464801&sr=8-1&keywords=dual+6v+battery+box

These don't vent/drain out the bottom or have a line running outside like these RV ones do. Does it matter? This is what was in my fifth wheel from the factory.

http://www.amazon.com/MTS-Company-200275-Vented-Battery/dp/B00KPR877G/ref=sr_1_2?ie=UTF8&qid=1457465287&sr=8-2&keywords=rv+vented+battery+box

Veebyes wrote:

GoPackGo wrote:

JCasper wrote:
Lyle, Thanks for that. For the price difference, I think I'm going to buy the 6V batteries at Costco. For $83.99 I don't think I can go wrong. They are Interstate GC2. They are not the HD GC2, but still plenty for what I'm doing and $100 cheaper then buying 2 Trojan T-105.

That's what I did for my trawler. They will work great.

Out of interest, what builder/model trawler did you have?

I have had a couple of Albins. First was a 27 ft cabin pocket trawler. Still have an Albin 32+2. Not a trawler style but a great single diesel cruising boat.

Current drool boat is a North Pacific. Never going to happen.

Sorry for the late reply - I didn't notice your question till just now.

I had a 1983 36' Monk. Supposedly one of only about 10-12 that were built with twins. Mine had twin Perkins 4-236. I used a pair of Grp 27s for starting batteries and 4 ea 6-volt batteries for house batteries with an isolator between starting and house batteries. When I bought the boat it had a pair of 4D batteries that were about gone. What a fun time it was getting them up and out of the engine room. Never did understand the rationale for using them.

I always liked the Albins.

Why not use 2 ea 6-volt marine boxes ? West Marine will have them. Or Amazon.