Replace never lube bearing with traditional bearings
Hey guys has anybody replaced Dexter never lube bearings with regular bearings? If so can the same hubs be used? Thanks in advance.
Forum Discussion
RAS43 wrote:
No. They have to be pressed into the hub with a larger capacity press. I had a machine shop do mine. And there is a pretty stout snap ring that comes out first.
Not to mention that they are anywhere from $100.00 ( Eastern Marine ) up to $150.00 ( Etrailer ) a piece depending on where you find them.. The number I listed was for the 50mm.. I am sure it can be had cheaper, but not by much....
