Forum Discussion

todd_j's avatar
todd_j
Explorer
Jan 05, 2021

Slide out drifts open

I have a 2009 Sierra by Forest River 335QBQ. It has 4 slides. The slide out on the fifth wheel end (bedroom) drifts open while the camper is just sitting there. It is connected to power. The slide outs do not work independent of each other. As one reaches it's final position the next starts to move. It's not like a could block a valve to the affected slide and stop it.

Any ideas????
Thanks
  • todd j wrote:

    Thanks for your reply. I'll try purging air out this weekend. I know it's not an external leak on cylinder because no sign of fluid anywhere. Could be an internal leak. I'll see what happens after I cycle the slides in and out a few times.


    That's what our was internal on the bedroom. But they both would creep out
  • My trailer has coroplast closing off the undercarriage. If you are insulated, any fluid leak could be masked or absorbed by the insulation batting. There is a feed and return line for each cylinder with 3 threaded fittings for each. So that is 6 per cylinder. If only 1 slide is slipping, then that is a starting point. Also, in a sealed system, if you are low on fluid, it is going someplace, indicating a certain leak. Remember to check the level with everything retracted, including your hydraulic landing gear. Shouldn’t be any air in an already operating system unless it was opened, or a worn part/seal. Good luck!