Using "maneuvering" position on slider
Hi, Normally, if you are backing into a tight spot, do you need to unhitch the FW, slide the hitch to maneuvering mode, re-hitch and proceed to park? Or do you simply remove the safety pins, and mo...
Forum Discussion
sele wrote:filthy beast wrote:me tooin5r wrote:
I have been making sure I am on a level surface when I do this but this is my procedure. If I am in towing position I move the handle to un lock,,apply my trailer brakes only,,,,slowly pull the truck forward till the hitch travels to the rear of the rails,,,apply the e-brake on the truck. Move the handle to maneuver. Everything goes the same when switching into haul. I always double check that the handle is fully locked into either tow, or the maneuver position before proceeding. If I am ever in doubt I do a trailer brake pull test to make sure the hitch does not slide on me. Hope this helps.
X2
Same here.
