What did you do to your Toy Hauler today???
This is always a fun thread to watch so I thought I would start one here.
Forum Discussion
Got my new tires mounted, balanced, and put on the toyhauler: I went with the Sailun 235/85-16 G-rated tires so we'll see how it goes. I'm starting out at 105 psi and will see how the temps go, and how things ride. I don't need the extra weight capacity, but wanted to get away from ST tires.
Installed the TST TPMS on the toyhauler tires. What a simple system to install and setup. I got the flow-through sensors but would probably go with the other sensors if I had to do it again. The air flow through the sensor is really slow, so adding air takes about three times as long as without the sensor. Not a big deal though, just slightly annoying. I used my new Porter-Cable CMB 15 air compressor. That thing is super. Ran the tires up to 110 psi from 90 psi with no issues. Love it.
While the wheels were off getting tires changed, I replaced the EZ-Flex equalizers with the new parts they sent me last year. These do seem to be a much stiffer rubber, as there is very little deflection compared to the old ones.
Got the parts to install a piezo-electric ignitor on the oven, so that is the next project.
I'm also interested in putting on some better non-slip stuff on the ramp. Just haven't decided what.
Installed the TST TPMS on the toyhauler tires. What a simple system to install and setup. I got the flow-through sensors but would probably go with the other sensors if I had to do it again. The air flow through the sensor is really slow, so adding air takes about three times as long as without the sensor. Not a big deal though, just slightly annoying. I used my new Porter-Cable CMB 15 air compressor. That thing is super. Ran the tires up to 110 psi from 90 psi with no issues. Love it.
While the wheels were off getting tires changed, I replaced the EZ-Flex equalizers with the new parts they sent me last year. These do seem to be a much stiffer rubber, as there is very little deflection compared to the old ones.
Got the parts to install a piezo-electric ignitor on the oven, so that is the next project.
I'm also interested in putting on some better non-slip stuff on the ramp. Just haven't decided what.
