What did you do to your Toy Hauler today???

I accidentally turned on the air conditioning instead of the furnace.

Recaulked the Shurflo fan in the rear of the toyhauler. It started leaking and when I checked it out I discovered the plastic frame was cracked in several places. Really tempted to replace it with a Fan-tastic Fan but just caulked it thoroughly for now.

Strabo wrote:

joebedford wrote:
Dumped all the tanks (fresh & waste) because of well below freezing temps forecast. Not cold enough to winterize through.

It's gonna get that cold There? Is that normal?

The forecast was for quite a bit colder than normal but just for one night. That would be a normal forecast for late November.

joebedford wrote:
Dumped all the tanks (fresh & waste) because of well below freezing temps forecast. Not cold enough to winterize through.

It's gonna get that cold There? Is that normal?

Dumped all the tanks (fresh & waste) because of well below freezing temps forecast. Not cold enough to winterize through.

I don't use the EZ lube feature myself, for a lot of reasons. I suggest it's time to do a full inspection of all axle and brake assemblies. Might as well, saves $$$

Double check the seal sealing area for nicks, gouges, dings, etc. I've seen quite a few of these things that have been assembled with badly damaged sealing area. The EZ-Lube regimen sometimes gets blamed for assembly when the actual problem is lousy/damaged bearing surfaces.

Lubricated the LR brake shoes. :M
Appears the seal was not installed properly and leaked during "E-Z" lube procedure.

Ordered new brake assembly and 4 seals.:(

Replaced about 6 feet of wall footer at front of trailer and about 5ft by 18" section of flooring. Screws in bottom of passthrough hatch on "low side" of trailer leaked last winter and rotted out the wood all around there. I have since added downspouts to keep the water from running down the side of the trailer. And of course, sealed up the screws in every hatch on the trailer.

lincster wrote:
Not sure where you are getting your 6V's at.
I got mine at Costco for $75 each.

Yeah, Costco, Sams Club, and Walmart all have good prices on 6V's. I stopped buying Trojans after government use drove the prices up.