What did you do to your Toy Hauler today???
This is always a fun thread to watch so I thought I would start one here.
Forum Discussion
2,288 Replies
- Replaced the city water inlet/valve. Split along mold seam where interior plumbing attaches. Water line/hose to water inlet too short. Replaced with PEX pipe and fittings. New city valve seeps under pump pressure. Replaced valve again. Still seeping. Going to install ball valve in new PEX plumbing to eliminate seepage. Easier than replacing the entire fresh fill, city inlet, vent assembly.
- Still looking at ours in the street....Days left to get ready are counting down. Had to rebuild a dresser today with glue and nail gun.
Fixed it. RUFFSTUFF wrote:
Yeah, I did more investigation: they're 60lbs and G-rated. Pretty good for a ST tire.
Yeah, but they are stout ones so...
My E-rated LT tires are 65lbs.- Ran the generator and pumped gas back into itself, just to make sure the pump is still working.
joebedford wrote:
RUFFSTUFF wrote:
Those are ST tires. Good luck.
Got 7 tires for the TH. These should work a lot better. Went from Freestar F-108 235-80/16 to Hartland All-Steel 235-85/16.
Yeah, but they are stout ones so...- Winterized both of mine too.
- Time to clean the inside, Vets Day Camp is 1 week away. Rhino needs cleaning too from last weekend's trip to the sierra's.
- Getting ready for the 2017 season:
- lubed the suspension
- lubed the bearings
- checked the brakes and repaired the wiring that was causing the rear two brakes not to work RUFFSTUFF wrote:
Those are ST tires. Good luck.
Got 7 tires for the TH. These should work a lot better. Went from Freestar F-108 235-80/16 to Hartland All-Steel 235-85/16.- Got 7 tires for the TH. These should work a lot better. Went from Freestar F-108 235-80/16 to Hartland All-Steel 235-85/16.
