Forum Discussion
2,288 Replies
- sin_cal_hdExplorer
qchunter wrote:
sin cal hd wrote:
qchunter wrote:

Finally got around to installing my sewer hose holder. Had to install under the front since the th has no bumper. It will be better than storing it over the generator.
Could you post a pic of the cap and latch? My parents want to do this to their trailer. Thanks.
Here you go. I can get a close up if needed, just let me know. I used a hinge on one side but had to trim the lip on the cap so it would open easily. The other side I used a hasp and found some pins that had a ring that held tension so it always wants to stay closed. Got it at home Depot.
Works for me thanks. Did you put a hinge on both ends of the tube? The pics look like 2 different angles of the hinge on either side. - qchunterExplorer
sin cal hd wrote:
qchunter wrote:

Finally got around to installing my sewer hose holder. Had to install under the front since the th has no bumper. It will be better than storing it over the generator.
Could you post a pic of the cap and latch? My parents want to do this to their trailer. Thanks.
Here you go. I can get a close up if needed, just let me know. I used a hinge on one side but had to trim the lip on the cap so it would open easily. The other side I used a hasp and found some pins that had a ring that held tension so it always wants to stay closed. Got it at home Depot.
- eDUBzExplorerNice sewer hose holder install. My 2013 powerlite came with the same one as ORbiker but one night we rolled up to camp ground and there was a small trough, I was to lazy to back up and go around, I decided to cruise through it and there was a rock sticking out the ground we didnt see and the sewer hose holder caught it and ripped off and my rear bumper has a dent. :)
- ORbikerExplorerMy 2016 380TH came with the sewer hose holder. It's a bit back of the rear door with openings on both ends.

- sin_cal_hdExplorer
qchunter wrote:

Finally got around to installing my sewer hose holder. Had to install under the front since the th has no bumper. It will be better than storing it over the generator.
Could you post a pic of the cap and latch? My parents want to do this to their trailer. Thanks. - qchunterExplorer

Finally got around to installing my sewer hose holder. Had to install under the front since the th has no bumper. It will be better than storing it over the generator. - joebedfordNomad III
Strabo wrote:
I did this well ahead of the recommended service schedule because on the trip to Texas a couple of months ago, it was surging a bit and occasionally hard to start. I figured the fuel filter was partially blocked. The plugs and air filter looked good, but what the hay, I had the parts and I was in there, so why not?
Smart man, if your like us and use your genny alot, you have got to service it.
I test ran it for an hour afterwards and it performed fine -started well and ran both A/Cs - no surging. - StraboExplorer
joebedford wrote:
Did a service on my Onan:
- oil and filter change
- air filter change
- change 2 plugs
- change fuel filter
Smart man, if your like us and use your genny alot, you have got to service it.
Our Onan Micro Quiet 4k has no oil filter, so i change out the oil every few trips with Mobil 1. - joebedfordNomad IIIDid a service on my Onan:
- oil and filter change
- air filter change
- change 2 plugs
- change fuel filter - StraboExplorerTime to pack!!!!!
About Fifth Wheel Group
19,031 PostsLatest Activity: Apr 14, 2024