What did you do to your Toy Hauler today???

Went into the garage of the Raptor. Sat on my Raptor 700 and made "BRAAAAP" noises...then hooked up a couple Battery Tenders to the my quad and my wifes.

Wizbangdoodle wrote:
Installed a new Trailair pinbox. Can't wait to see how that affects towing.

I have one, and it's great!

Installed a new Trailair pinbox. Can't wait to see how that affects towing. Also installed my inverter, about half-way done with that.

Awesome pic !

Looked at it while moving more snow

Once again I wished I was using it instead of it being in winter storage.

After getting the trailer back from the dealer after 2.5 months, yes, you heard that right, 2.5 months, I put remote locks on both doors from RVlock.com. Easy and they work great.

Replaced water drain low point hoses.
Replaced genny exhaust bracket.
Replaced 1 1/2" fresh water drain knife valve.
Rebent latch to keep rear door shut.

dcmac214 wrote:

Strabo wrote:
More LED bulbs, rodent repellant bags just in case. Drained fresh water, too hot outside afraid it will algae. Bungeed tire covers so wind won't blow them off.

Bags that repel the vermin or bags (throw paks) of poison?

No, repellent bags I bought at our RV mechanics shop. I have 3, 2 in the storage areas, and one in the rack that holds the propane tanks. I also have a bait station secured near the rig, that station works great. I recently discovered droppings in the generator compartment, just a few, and they were blueish green.

Means the bait station is doing it's job. I hope the repellent bags are too.

Fabbed up a custom piece of 7075, .25" aluminum plate that integrates with my existing l-track and PitBull Trailer Restraint System for my race bike. Now I can avoid having to drill through the floor to mount the system and position the bike along with entire length of either side of the trailer depending on weight distribution requirements.

I still have a couple l-track lugs that are missing (they got lost in the mail, apparently), need to round off some of the sharp edges, and am going to mount some strips of PVC or Delrin on the bottom of the plate to take up some of the space between the floor and the plate to eliminate any possibility of flex. As it sits right now, though, it's plenty secure.....