Would you pay a welder to reinforce your 5th?
I'm considering paying a RV industry welder to add gussets /reinforce the welds in the under deck / pin box area. A warranty repair for a crack under the bedroom slide was just completed. As part ...
Forum Discussion
fj12,
There is a huge amount of design goes into the frames. Then the manufacturer sets the cost limit of how much of it they are willing to pay for. The "acceptable" failure rate is not set by the engineers and the ultimate design is reduced as long as basic life-safety standards are maintained.
Money talks!
(What weight WF beam are you running for that 40' span?)
There is a huge amount of design goes into the frames. Then the manufacturer sets the cost limit of how much of it they are willing to pay for. The "acceptable" failure rate is not set by the engineers and the ultimate design is reduced as long as basic life-safety standards are maintained.
Money talks!
(What weight WF beam are you running for that 40' span?)
