Atwood Water Heater Blowing Fuses
My Atwood 6 gallon water heater Mod. G6A-BE blew the 2amp fuse located on the circuit board when I switched it on. I replaced the fuse and tried again but it blew a fuse again. This time I took the ig...
Forum Discussion
It is most likely a bad circuit board. Remove it and look for burnt place on the back side. Oops, can't do this on Atwood potted boards!
Look at your furnace circuit board. Many use the same one. Switch it out temporarily and see if problem goes away.
If new circuit board is required, get a Dinosaur Electronics version.
Verify model, as I believe yours is a G6A-8E.
Look at your furnace circuit board. Many use the same one. Switch it out temporarily and see if problem goes away.
If new circuit board is required, get a Dinosaur Electronics version.
Verify model, as I believe yours is a G6A-8E.
