Glad you all liked the pics.
A friend did the woodwork for me. The cabinet is all one piece and is removable with 7 screws - two on each side just above mid-shelf, one at top center, and the two that fix the friction latch at the front lower right. My friend did a wonderful job of keeping it light and easy to remove. Even the door panel is changeable by removing the screws that hold the panel's retaining frame in place (see inside of open door).
Now to find a TV and figure how we want to place it. I have been learning a lot about small LCD TV's, with the most interesting fact (and important to RVers) being that beginning 3/1/2007, all TV sets shipped from manufacturers must have a built-in digital tuner if the set is to have any tuner at all. Currently, no small LCD sets (under 25" diagonal) that I have seen have digital (ATSC) tuners - they only have the familiar good old analog (NTSC) tuners - and there will be no over the air (OTA) analog signals after 2/17/2009. This means your RV crank-up antenna will do you no good unless you buy a set top digital tuner to go between your antenna and your TV. I think older analog sets can somehow play the digital signal from a set top box, they just are not any sharper (i.e., not High Definition).
I was prepared to do like most folks and ignore this lack og a digital tuner until I realized that my RV antenna has a power booster, and while it catches snowy pictures when in parks located at some distance from towns that have a TV station, that TV station may be simiutaneously broadcasting in digital, and my antenna may just catch it. Unlike analog signals, if you can catch the digital signal at all, it will be a near prefect picture - no snowiness. So having the potential for clear TV over the air today makes me want that ATSC tuner in my little LCD TV today.
LCD sets above 17" start to get kinda heavy and thus are not so easy to store in a cabinet when not in use, and this storing-away is probably the route we will go. A TV may look good attached to that big door, but the viewing angle is not so comfortable, and hardware to flex it down gets bulky.
I guess I'll wait a few weeks to see if small LCD sets built with both NTSC and ATSC tuners start showing up before picking one.
Do any of you know any more on this matter?
On edit, I have posted this question on the Technology Corner Forum as well.