brake fluid?

Starrs wrote:
where is the master cyl at? I need to put brake fluid in and I dont know where? 1989 fleetwood southwind----sorry ---chevy

If a GM chassis its on the front frame...just inside of the drivers side front wheel.and CAN at times be a real BIT** to check and / or add fluid to

chances are you have very worn brakes or a leak somewhere in the system. When my class C did that the back brakes were toast and the master cylinder was leaking. Nothing 800 bucks does not cure. I also needed the drums replaced. They were cracked.

Paul

truthfully we dont, the brake light came on for a few minutes then went off---so we were going to check the fluid level before checking the brakes, but just couldnt find where to even check the fluid ----the book said to check the master cyl. but didnt tell where it was--lol
the brakes were working fine--just the light came on---we got this camper in December and only drove it from NC to SC so far--not put much time with it because of work--going to have fun this summer though.

How do you know you need brake fluid if you do not know where the master cylinder is to check it in the first place?

I have a 1988 southwind. You have to turn the front wheels as far to the right as they will go, squeeze up inside of the left wheel and look up. a REAL PITA hope this helps

thanks for all the help---my husband is looking now----you guys are very helpful. thanks again

bsinmich wrote:
On my Chev. P30 it was visible from the LF wheel well. It is probably time to do a complete flush of the brake fluid rather than just adding some. Moisture gets into the fluid and will cut your braking ability as well as create rust in the system.

x2 on all of this
An additional word of advice: when I did a complete flush on mine the front brake hoses swelled shut. Could've been the new fluid, I don't know. In any case, if your fluid is due for a change then your hoses probably are too.

On my Chev. P30 it was visible from the LF wheel well. It is probably time to do a complete flush of the brake fluid rather than just adding some. Moisture gets into the fluid and will cut your braking ability as well as create rust in the system.

If you need to add very much then your brakes are either worn or leaking.

Mine was under the floor board under drivers seat. Little trap door that lifted up and master cyl was under it. Just mine, yours might be different. But don't remember if it was 89 or 87 but around that year.