Broken Window

3Lakes Steve wrote:
There is screwed on interior trim around the window that appears to hold the unit in place. The sliding window is in a channel with some sort of vinyl strip at the bottom for the window to glide on. No room to lift out. Can't really tell how you might separate the frame to get the window out?

I have successfully removed Atwood sliding window glass with out removing the whole window. This technique might work for you.

1: Slide window open.
2: The channel/welting should be on bottom, top and one side. Use putty knives, pliers or what ever it takes to remove the channel welting.
3: With the welting out and the glass dropped down, it will be with in 1/16" of coming out the top. Loosen the frame screws. Use the putty knives to wedge the glass out of the frame. The frame will spread.
4: Reverse process to install new glass.

Richard

Look at the DOT number in the lower right corner of the glass. Google that number for the manufacture of the window. Then place your order.
Or a glass shop can have the glass cut and tempered but good luck getting the exact same tint.

Richard

Since most likely you will have to order the glass via dealer, they will know how to do it.
In the mean time put blue masking tape over it.

There is screwed on interior trim around the window that appears to hold the unit in place. The sliding window is in a channel with some sort of vinyl strip at the bottom for the window to glide on. No room to lift out. Can't really tell how you might separate the frame to get the window out?

Glass shop will not cut heat-treated glass for you.
You need to custom order it and manufacturer is probably the best start.
Can you unscrew the window frame from the coach?

Does anyone know how to get the window out of the frame? It's the operable window, and my thought was to take it to a glass shop for replacement.

Shattered mine with the lawnmower. Cutting the grass hit something, it bounced off the side of the house and hit the window. Later that day came out and the window was shattered. It must have hit the window and chipped it, later when it got hot the window shattered. I tried blaming the dog, but she just gave me that look "Really you are going to blame this on me".

To me when I blow the picture up it looks like a slight impact from the right side in the middle of the glass. The cracks seem to radiate from that point. Having said that if it is safety glass it has a lot of surface tension built up to the mfg process, some upwards of 10,000 psi. With an Al frame that expands twice that of glass in the hot sun trapping it, it would not take much of an impact to shatter it. Another problem occurs if the edges of the glass are not smooth or polished a crack can start from there. If you notice that the safety glass breakers have just a small diamond tip that will shatter the glass better than a hammer because the psi is greater.

That does not look like impact damage.. It looks like heat stress. I have seen both several times. If it was impact damage it would have to be a hit from something far too big for the lawn mower to toss since the entire window is shattered with no point of impact apparent (Something like a flat shovel swung might do it) a rock would have left a clear point of impact. with lines radiating.

Steve, whatever the temperature is outside it will be 7 to 10 degrees warmer in the direct sun. One year before I retired, I worked the overnight shift and was driving home and got a rock ding on my windshield. When I woke up in the PM it was 80* and the ding turned into a large border to border crack. My trip to Novus ended up replacing the windshield.