Dometic Comfort Control 2 Thermostat issue
Dometic Comfort Control 2 model#3314080.xxx(without dehumidify) My zone 1(front AC/HP) HP mode seems to be stuck on HP/FURN it trys to start then it flashes HP then to FURN and will not run the heat...
Forum Discussion
thestarfinder wrote:
Not sure what the ambient temp sensor looks like??I will look for it on line.
The CC2 and the 2 AC/HP units were installed together(5/16/13).Never had a problem before now.. The units are:2 Dometic 15000 btu Model # 561816CXX1C0.
I will try to switch out the sensors tomorrow....
thanks for responding,Tom
On the 5 button CCC board it was the 2 wire RED plastic connector. On the CCC2 board it is the 2 wire RED wire(white connector) that connects to the P3 connection on the end of the board. Doug
