entrance door hold open latch?

Many of us have problems with the scissor closer on the top of the door. Mine will open and then stay open and not allow a slight pull get is closed. Need to start it by hand and am too cheap to put new unit on top. There is an indent in the scissor unit that should hold it but often times does not.

Thanks Dalenoel, when I get it back to my shop next month I will remove the scissor bar at the top and see if I can tighten the pin that looks to be worn and lets that bar move off the detent.
Bill

Mine front door works sometimes and sometimes not. So a easy fix is get a bungee cord and hock to door a front mirror bracket, works good and cheap fix. Door will stay open

After removing and repairing the scissor hinge on my 08 Camelot several times I went with a gas strut to hold the door open. After some experimentation I determined a 20 lb gas strut would hold the door in moderate side wind. It takes very little effort to pull the door closed so this has worked well for me for several years.

BigSkyBob wrote:
After removing and repairing the scissor hinge on my 08 Camelot several times I went with a gas strut to hold the door open. After some experimentation I determined a 20 lb gas strut would hold the door in moderate side wind. It takes very little effort to pull the door closed so this has worked well for me for several years.

Thanks, maybe a better idea. Our last coach the door stayed open till you pulled the interior handle

I fixed mine by bending the detent up after the pivot with a large crescent wrench so it goes into the dimple with more force. That was 10 years ago on my 04 Dynasty.

Ivylog wrote:
I fixed mine by bending the detent up after the pivot with a large crescent wrench so it goes into the dimple with more force. That was 10 years ago on my 04 Dynasty.

Thank you, I'll check in to that solution first

Had the same issue. Got a new scissor latch after a few months the same problem. Had the RV dealer look at it the tech used two ball peen hammers. One on top and one on the bottom. while holding the larger on up against the bottom he hit the top very hard a couple of times. That fixed the problem. Now every few months I do the same. That keeps it tight.

Roger in VERMONT wrote:
Had the same issue. Got a new scissor latch after a few months the same problem. Had the RV dealer look at it the tech used two ball peen hammers. One on top and one on the bottom. while holding the larger on up against the bottom he hit the top very hard a couple of times. That fixed the problem. Now every few months I do the same. That keeps it tight.

Huh! A 2 hammer repair, my favorite repair tool :) Thanks

Had that problem, called the door manufacturer and got a replacement scissor latch. Prompt shipment. Have not had problem since replacement.