EPDM Roof Bubbles
I have an EPDM roof with some rather large bubbles. How do I seal the roof down again and what product do I use to seal it down before I overcoat the entire roof? What product have you found best to...
Forum Discussion
Check YouTube for videos on repairing the bubbles. You should probably use the same type glue used for installing the roof.
Last summer I restored the roof on our 96 Southwind. I did not have any bubbles. All seams were covered with Eternabond.
I used Heng's Rubber Roof Coating. It goes on easily, does a nice job and looks good.
Heng's requires no primer. I used a 4" roller to apply the coating. I chose the 4" because I was not in a hurry and had better control.
A brush was used for trimming.
So far it's held up to sun, snow, ice, rain and Pennsylvania's freeze/thaw cycles. No peeling or leaking.
Last summer I restored the roof on our 96 Southwind. I did not have any bubbles. All seams were covered with Eternabond.
I used Heng's Rubber Roof Coating. It goes on easily, does a nice job and looks good.
Heng's requires no primer. I used a 4" roller to apply the coating. I chose the 4" because I was not in a hurry and had better control.
A brush was used for trimming.
So far it's held up to sun, snow, ice, rain and Pennsylvania's freeze/thaw cycles. No peeling or leaking.
