for those of you that have dropped your gas tanks
Was the tank full of gas or did you empty it? is it hard to drop a tank that is full?
Forum Discussion
When replacing the pump/sender on my F150 when it started to go bad, I ran the truck to get it as empty as I could. Kept a 2.5 gal gas can in the bed the last few trips in case I pushed it too far. Also had a rubber hammer to tap the tank with to get the pump running when it wouldn't start as the pump was dying.
If you can borrow an ATV jack, it worked well for me. All applications are different but releasing the vent lines and inlet hose were the most difficult parts of the job. Just make sure you get a good quality replacement. Went with a new Motorcraft unit for my Ford. Replaced the vent at the same time.
If you can borrow an ATV jack, it worked well for me. All applications are different but releasing the vent lines and inlet hose were the most difficult parts of the job. Just make sure you get a good quality replacement. Went with a new Motorcraft unit for my Ford. Replaced the vent at the same time.
