Refrigerator drip from bottom of door

Mine does that in high humidity and I know that my seals are getting worn out. Hoping someone comes up with a good way to replace them as they are molded into the door. I would guess it is your seals. They get dry and brittle.

Thanks bob,
I can check that when I get back in. Never thought of the drain line.

OK, now that we have that much info. Open the back from the outside and there should be a pan back there, with a plastic hose laying in it. Pull the insert out of the hose, which is most likely clogged up and clean it. Water may come pouring out, so have a can or bottle ready.
Once done put the little valve back in and let it slow drip into the pan. It will never fill up and overflow, as evaporation always stays ahead of this happening.

Do this , and, check to see that the hole in the nipple attached to the drip pan is clear. On my "Nevercold" the hole was not drilled all the way through. The refer had been leaking for ten years when I got it and had it fixed the first day.

gssonnier wrote:
Thanks for suggestions, I'll look into all. I'll try to get fridge info update later,
Presently away from home. But fridge is a Norco.
New to the forum, I'll try to update my info in more detail, thanks again

OK, now that we have that much info. Open the back from the outside and there should be a pan back there, with a plastic hose laying in it. Pull the insert out of the hose, which is most likely clogged up and clean it. Water may come pouring out, so have a can or bottle ready.
Once done put the little valve back in and let it slow drip into the pan. It will never fill up and overflow, as evaporation always stays ahead of this happening.

One other thought - check the items in your fridge - I had a 1/2 gallon of purchased ice tea develop a pinhole leak in the bottom (was still within expiration date).

Thanks for suggestions, I'll look into all. I'll try to get fridge info update later,
Presently away from home. But fridge is a Norco.
New to the forum, I'll try to update my info in more detail, thanks again

How to make your signature so we can serve you better:

1. Log on and click "My Preferences".
2. On the "My Preferences" page click the middle box and enter your rig info.
3. Scroll to the bottom and click "Submit Changes"
4. Exit and you're done.

tommy g wrote:
Brand?...model? age?

As you can see, we need a lot more info about your rig and the specific equipment you're addressing. Most find putting that into your signature block saves having to type it over and over.

Could be the seals. It won't hurt to give them a real good cleaning. It might have crud on it somewhere you don't readily see. All it takes is a small spot for air to creep in.

Brand?...model? age?