1. LCI states to never stop before extending or retracting
2. I do this ALL THE TIME when working on the RV's with no problems
3. Now, regardless of full or partial retract or extend, all you have to do when the room is fully Extended or Retracted after ANY operation whether Partial or Fully is to hold the Button down for 10 seconds after Fully retracted or Extended. This resets the counter on the module. This holding the Extend or Retract for 10 seconds has always been required on Scwintek Slides. IF you do not do this and the counter gets slightly out of Synch, then after a few times the room comes in crooked. IF this happens, just fully Extend or Retract whichever is closer and hold the button down for 10 seconds. Doug
