Swapping out the Water Pump

YB, that s ucks. Hopefully someone with the same camper has some pointers.
That would really hack me off. No good reason for that, and it doesn’t make sense as the black and gray tanks is generally right under the toilet and shower.
Be sure you’re looking at it right.

If you increase the pump size/pumping pressure, make sure your 12 volt system can handle the increased amp draw. Can't remember brand name or generic name of current regulator device that may be needed.

Our motor home has an outside service panel to the fridge which is also a vent for the fridge. You can see it in this picture, located above the rear tire. I believe every motor home has a similar vent for their 2-way or 3-way absorption fridge. If the water pump was behind the fridge, wouldn't it be susceptible to freezing?

ron.dittmer wrote:
Under the shower pan?
Behind the toilet?
Behind the fridge?
What were those manufactures thinking?
Apparently not thinking.

And that's how deep the shops and dealers charge replacing the pump.

ron.dittmer wrote:
Under the shower pan?
Behind the toilet?
Behind the fridge?
What were those manufactures thinking?
Apparently not thinking.

If you look real close, on the last page of the owners manual, it states "assembled by disgruntled employees" . :E

One of the things I liked about my old Gulfstream, even though the build quality was not top notch, was the ease of servicing things like the water pump. Mine was inside a compartment, just screwed to the floor under the water tank. It could be changed in less than five minutes. In fact, as part of my winterization process I just removed the pump and put it in my garage.

Under the shower pan?
Behind the toilet?
Behind the fridge?
What were those manufactures thinking?
Apparently not thinking.

Look for a front panel to remove for access to the pump under the shower.

Yes, some pumps are terrible to change. On my Nash 26X you have to pull the refrigerator to get to it as confirmed by the factory.

If you go to the trouble of changing, look at doing these items to it.

1. On the hoses coming and going to the pump, go to HD and buy some of the gray foam pipe insulation to keep the pipes / tubing from bumping into things when the pump is turned on and off.

2. Place some rubber or rubber washers under between the pump and the floor. It will stop some of the pump vibration transmitting into the wood floor.

3. Install a small accumulator tank usually available for $35 to $40.

Bill

YB,

Get to the Forest River owners group. Potable pumps are a common service item so I doubt that it is that difficult to get out and replace. I do not personally know about your unit.

Matt