What did you do to your Class A MH today???
This is always a fun thread to watch, so I thought I would start one here.
Forum Discussion
bigred1cav
You might have read about the rear trac bar on here. It is put on the gas f53 chassis to help with the wandering. I was getting an aliegnment and found the bracket for the frame there. The bracket for the rear end I had manufactured at a steel manufacturing site. It was made out of 1/4 inch steel. The cross bar I found at tractor supply. It comes in different lenghts.
If you go to oemys-performance.com and click on trac bar you will see what I have done. It will also give you a diagram that you can use. I had to blow it up and then crawled under to make sure it would fit. The distances are correct if you lay down the template on the piece of steel you had cut out. Let me know if you have anymore questions.
You might have read about the rear trac bar on here. It is put on the gas f53 chassis to help with the wandering. I was getting an aliegnment and found the bracket for the frame there. The bracket for the rear end I had manufactured at a steel manufacturing site. It was made out of 1/4 inch steel. The cross bar I found at tractor supply. It comes in different lenghts.
If you go to oemys-performance.com and click on trac bar you will see what I have done. It will also give you a diagram that you can use. I had to blow it up and then crawled under to make sure it would fit. The distances are correct if you lay down the template on the piece of steel you had cut out. Let me know if you have anymore questions.
