What did you do to your Class A MH today???
This is always a fun thread to watch, so I thought I would start one here.
Forum Discussion
Yesterday I replaced a hose that was starting to show that it had been rubbing against a angle iron from the battery compartment. The hose on the Caterpillar engine goes from the CAC to the engine turbo charger.
It was a piece of cake to change out. Big hose 4.5" on the CAC end and 3.5" where it attaches to the engine turbo, and 35" long.
I also replaced the topper on the living room, kitchen slide. That took me about two hours but fairly easy to change the vinyl material on it. Once you pin the cylinder the rest is easy.
I also order the two air conditioner shrouds to replace them since I noticed that they were starting to get some small cracks where the screws go. One come in already and I installed it right away. The other should come in Monday from Amazon.
Just got back from a trip and decided it was time to do a little maintenance on the coach, get it ready for another trip in October and the balloon fiesta in Albuquerque, N.M.
It was a piece of cake to change out. Big hose 4.5" on the CAC end and 3.5" where it attaches to the engine turbo, and 35" long.
I also replaced the topper on the living room, kitchen slide. That took me about two hours but fairly easy to change the vinyl material on it. Once you pin the cylinder the rest is easy.
I also order the two air conditioner shrouds to replace them since I noticed that they were starting to get some small cracks where the screws go. One come in already and I installed it right away. The other should come in Monday from Amazon.
Just got back from a trip and decided it was time to do a little maintenance on the coach, get it ready for another trip in October and the balloon fiesta in Albuquerque, N.M.
