What did you do to your Class C MH today???
This is always a fun thread to watch in other forums, so I thought I'd start one here.
Forum Discussion
ronfisherman wrote:Okay Ron here you go... First Remember that this modification will void your warranty on the compressor. With that in mind:
I have the same compressor. Please report back when you get your hose modified. I have not found anything that will work yet.
1. Remove the OEM quick disconnect fitting
2. Use a 1/4-18 NPT tap (smear grease on the tap) and run it in part way, then remove it clean the debris, repeat the process, till it's done.
Keep the hole down if not using grease on the tap so when you tap the shavings fall out.
OR... Remove the head (4 socket head cap screws on top) and put it in a vise. Make sure and pay attention to the gaskets and intake "plenum" when you disassemble the head so you can put it back together correctly.
By doing this you can use any standard 1/4-18 NPT fitting and then add a standard Quick disconnect, air hose and chuck.
Remember this in not a large compressor and is not designed to run air tools. It only puts out 2.5 CFM and has a has a duty cycle of no longer than 40 minutes.
Ken
