Windshield Wiper question with picture

Believe what you need is called the "windshield washer nozzle kit." I had to replace mine after a dealer service dept screwed them up. I ordered from Lichtsinn Motors in Forest City IA (Winnebago & ?? dealership) for $10.25 per kit. There were parts I didn't need, but that's how it comes.

psmoore wrote:
Just put on new windshield wipers and for lack of knowing what the piece is called isn't on the new wiper. In the pic you will see what I mean. I don't know what to ask for when I call for parts. Any suggestions would be great. Thanks. Both of these pieces were broke on the other ones.

Paul

Paul, it should be attached to the arm not the blade. Drive your bus to a good auto parts dealer and ask them to look for aftermarket attachment to replace the broken ones.

NAPA usually has a local owner and that owner usually has experience far beyond reading the computer screen.

Call the coach manufacturer and get the solution they offer if they offer no solution get the wiper arm brand put on your coach. No MH Manufacturer builds those parts.

Or duct tape. Fixes anything.

But seriously, I'd do what the others said with a zip tie.

Thanks for all the tips. I will rig it up tomorrow.

I used a dab of silicone adhesive and two very small black zip ties. Pull them tight and clip off the tails on the ties and 4000 miles later all is still good.

You can pick up the replacement hose at any auto parts store by the foot. Take in the old one for sizing as there are several sizes. Sun eats them up eventually.

McGyver it.

It looks like you would be able to position it onto the wiper arm and secure it with a few small wire ties (zip ties).

The old one was a bolt and the new one was the same except a screw instead. But the plastic clips were broke

How did you attach the new blade to the arm? I assume you attached the new blades in the same manner as the ones you took off. Do the attach differently?