Dead NOOK.
Hee hee. I thought I was fair at soldering but when the umbilical port socket broke away from the board. Not pin head size pads - pin point. Wave soldered at the factory. I have 90% remaining batte...
Forum Discussion
Article .. cracking open the nook touch with glow light
adding wireless charging to nook glow
the article is about adding a samsung wiress charge pad inside the nook
whats important is the (2) easy to use solder connections
use the same connections for other chargers
adding wireless charging to nook glow
the article is about adding a samsung wiress charge pad inside the nook
whats important is the (2) easy to use solder connections
use the same connections for other chargers
Whilst the PCB on the Glowlight is far more densely packed than the Simple Touch, and some of the test points are absolutely tiny, this modification turned out not to be as difficult as expected. The only points you need to access are reasonably large and marked GND and V-BUS. They’re on the more accessible side of the PCB even though the USB connector is on the other.
