Directv getting channel loss 771 but not really

Bill.Satellite wrote:
The standard SWM LNB can only handle 8 tuners. Maybe he installed a SWM16 LNB.

He did install a 3D2LNB, which supposedly supports up to 16 lines and we have a 28 volt PI. I still get an occasional 775 on my Genie. As a last resort, I will change one of my DVR's from "dual" to "single" if the 775 continues to be an issue. I would prefer doing this to having another tech come, during our quarantine. My wife has several of the high-risk conditions.

The standard SWM LNB can only handle 8 tuners. Maybe he installed a SWM16 LNB.

The DirecTV tech came yesterday.

I had a system that used a legacy LNB, ran all 4 coaxes to a box mounted outside. From this box, the two Coax ran inside to 2-8 way SWM splitters. The system wes powered by a 28 volt PI. At the time, I had a Genie. three DVR's and a receiver, all requiring 12 lines. One of the 103 connectors was badly corroded and barely making up.

The tech said that was all outdated. He removed the LNB and replaced it with a SWM LNB. Now I have 9 lines running off one SWM LNB, still powered by the 28 volt PI. which I thought wouldn't work, before, but it is working fine. Don't know what's changed to allow 9 lines to work off one splitter.

I have been using the same Slimline dish/LNB on a heavy duty tripod for 9+ years full time. The dish has been through a lot and set up I have no clue how many times. My tripod is weighted with a 5 gallon bucket of water so 40 pounds plus the weight of the bucket. Last week we had a sudden thunderstorm that hit with estimated 50-60 mph straight line winds and blew the tripod over and of course it landed right on the LNB. I put it back up and started aiming. All sats were mid to high 90's except 99ca. I could not get it above 82-84 until I realized the LNB arm was not only bent but it would move up and down about 1/4" and all of it's mounting bolts were tight. It seems the arm mount location on the dish was bent a bit also. Soooo, I grabbed my backup dish that I have been hoarding for a number of years and put it in service with my original LNB. Now all is well again with all sats above 95.

Why did the wind have to hit my dish from the back so it would fall on the arm? That black cloud, literally, was following me around again.

Did I try to call DirecTV for assistance? Didn't waste my time.

I still get the 771. I've tried moving my three coax connections around on my two 8 way splitters. I need the two splitters because my three DVR's need 9 lines. Nothing seems to help.

My signals are all in the 90's except for 99 Ca which stays in the low 80's. No transponders in the 70's.

I've operated, when traveling, with transponders in the 70's but this never caused any problem. I've checked signal strength many times during this 771 situation and never seen anything that would cause this.

I finally got through to DirecTV on the phone and have a guy coming tomorrow. I will not be surprised if the LNB is the problem. If I had a spare legacy LNB I would have already tried it.

All satellites have a bit of a wobble. I saw the message the other day, repointed the Trav'ler but still saw the message from time to time. Nothing has changed but the message is gone. It could well have been something related to the satellite or the upload between the ground and the satellite. Bad weather in Gaithersburg, MD (if they are still there) can degrade the overall signal.

We experienced somehing similar a couple of years ago. We were getting the dreaded "771 loss of signal" message too even in clear weather and we have NO trees to obstruct. Long story short, what it turned out to be was our satellite dish (over the years) had been bumped or whatever and was out of alignment! We had a Direct serviceman out to check things out, he replaced our LNB (even though he didn't really think that was it) and re-tuned the dish. NO more "771" messages since!

It's hard to say what's going on in your situation but this is what ours turned out to be. Good luck!!

Dan

mikestock wrote:
...There has been no interruption of signal, just the banner along the bottom of the screen....

If the picture keeps coming through despite the 771, could it be another channel you are recording such as a local that you are out of the spot beam for? That is the usual cause when I see the 771 (unless there is a thunderstorm in the way).

Bill.Satellite wrote:
Satellite AR is not 100% accurate and certainly not something that would indicate if your signal is blocked or not. It's just a general guide.

I know it the satellites move about on the phone's screen but I got the limb down anyway. Using a compass and inclinometer I am positive there is no blockage. As I said all of my signals remain constant in the 90's. I have not seen any actual signal loss, just the "771" banner saying "Loss on 1", at the bottom of the screen.

Haven't seen it once today, even though we're having thunderstorms.

Satellite AR is not 100% accurate and certainly not something that would indicate if your signal is blocked or not. It's just a general guide.