Dish 1000.4 to Hopper 3 Installation
I have a Dish 1000.4 and standard LNB for both WA and EA. I have been told that I do not have to switch out my dish and lnb if I use a DPH 42 switch. I understand that I need three cables from the LN...
Forum Discussion
TechWriter wrote:Bill.Satellite wrote:
Good point. I did not notice that but you still need a Solo Node, don't you?
Solo and Duo Nodes aren't used with Hopper 3s. Hybrid Solo Hubs and Hybrid Duo Hubs are used with Hopper 3s.
However, if you're just using a single Hopper 3 (and no Joeys), you can connect the output from a DPH42 or a DPH LNBF directly to your Hopper 3.
Thanks. It appears I am really out of the look on the Hopper 3 setup.
