Dish 1000.4 Western Arc aiming
I have a Dish Network 1000.4 with the Western Arc LNB setup in Northern OK. My tripod shaft is true vertical, I have the elevation and skew set correctly for this Zip code, and I have a signal on my ...
Forum Discussion
To answer one question, my system including the lnb was new this spring. And for Bill, after I ran the check switch without cable connection for the 38 tests to clear out the receiver I then reconnected the cable and ran a check switch again for tests 1 thru 4. After that my system completed the signal and directory download.
I then checked the guide and found channels that we normally receive that must be on 110 are not listed so that is when I went to menu-6-1-1 to see sat signal strength that I reported above.
I then checked the guide and found channels that we normally receive that must be on 110 are not listed so that is when I went to menu-6-1-1 to see sat signal strength that I reported above.
