Help pointing directv dish
Gang I'm at home trying to help a buddy who is out camping and trying for his first time to set up his directv satellite system - i think hes a bit overwhelmed right now. Problem is I'm a dish use...
Forum Discussion
Bill.Winegard wrote:
The HR24 does not require SWM as the DTV installer indicates. It will work with the LNB you show (if the LNB is working). You need to go into the receiver setup and change this before anything else will work.
Go to Menu, Settings, Satellite, Repeat Satellite Setup (enter a dash, found below the 7 key). Here you will select 18" round and that should change the switch type to Multiswitch. Now you can go to the link to Signal Strength and then Signal Meter. With this screen up, and some serious patience you will eventually find the 101 satellite, peak it up until you see a signal in the 80+ range (if you can only get 70's that's OK for a first try). Once you get a good signal, continue on through the setup routine, don't just get a signal and exit. Once complete you will be watching TV. This change in setup will need to be completed every time your friend switches between the home antenna and this style antenna so be sure to have him write down the settings he finds in the Repeat Satellite Setup
routine BEFORE he makes any changes so he knows how to reset it when he returns home.
excellent,excellent advice on all points,sure wish i had known this prior to finding out just how good.
