Forum Discussion

ScottG's avatar
ScottG
Nomad
Nov 16, 2017

King Jack ant.

I want to install a Jack ant on our new TT. The location it would have to go is a bit tight because there's a cabinet door that would swing over the inside part.
Can anyone who has one of these tell me what the overall height of the inside control unit is?
I have 2.75" of clearance.

Thanks,
Scott

6 Replies

Sort By
  • rjsurfer's avatar
    rjsurfer
    Explorer
    Nov 18, 2017
    Scott,

    I'm thinking about swapping out my Jack passive OmniPro antenna and would like to know what size holes you had to make to install the King Jack version,

    And any thoughtful tips on the job.

    Thanks

    Ron W
  • ScottG's avatar
    ScottG
    Nomad
    Nov 17, 2017
    Thank you both Merrykalia and chindog. I had actually emailed King and when they finally got back to me, they said it was 1". I had installed one in our last TT and pretty much knew that was wrong.
    It's folks like you that make this forum great again (sorry). ;)

    Scott
  • Merrykalia's avatar
    Merrykalia
    Explorer II
    Nov 16, 2017
    I measured ours and it was a bit more than the 1 7/8, but less than 2".
  • ScottG's avatar
    ScottG
    Nomad
    Nov 16, 2017
    Merrykalia wrote:
    We have one on our camper and it doesn't hang down far at all. Maybe 1.25". I will try to get out there and measure it this afternoon.


    Thank you so much!

    Scott
  • Merrykalia's avatar
    Merrykalia
    Explorer II
    Nov 16, 2017
    We have one on our camper and it doesn't hang down far at all. Maybe 1.25". I will try to get out there and measure it this afternoon.

About RV Must Haves

Have a product you cannot live without? Share it with the community!8,796 PostsLatest Activity: Apr 10, 2025