KVH Tracvision R4 - Flash problem
So I was all set to update the main and rf board. Main board went fine however when it came to the rf board it briefly did something then gave me the **cycle power to antenna to reset** message. I turned the power off then back on but nothing.
Long story short...I tried several times and even reflashed the main board and went back to the rf with no change.
Well....some change, now when I turn the switch on (the one beside the main board serial port) the led light comes on (whitish amber)but now I can't hear the dish inside the dome above me doing anything...nothing.
I checked the 3a fuse immediately behind the switch and it's good (plus the led is on..hrmm)
I'm stumped over the rf flash problem and now the dish not even turning at all.
Long story short...I tried several times and even reflashed the main board and went back to the rf with no change.
Well....some change, now when I turn the switch on (the one beside the main board serial port) the led light comes on (whitish amber)but now I can't hear the dish inside the dome above me doing anything...nothing.
I checked the 3a fuse immediately behind the switch and it's good (plus the led is on..hrmm)
I'm stumped over the rf flash problem and now the dish not even turning at all.
