Solid Signal says no Dish Hopper 3 in RV.
Their product description says... “A software upgrade may be required if this receiver is being installed in RV or marine application. Contact a customer service rep with your order # to make upgra...
Forum Discussion
I planned of doing the initial setup with my tripod mounted 1000.2 just to reduce the number of variables until I had the basics configured, so that should all work out.
The people that installed my Trav’ler ran the cables through a very inconveniently located patch panel. Then, just to make things more complicated, they only ran two of the three cables. Getting the DPH42, hub and A/B switches setup will take some work. The cable ends just aren’t where they need to be.
The people that installed my Trav’ler ran the cables through a very inconveniently located patch panel. Then, just to make things more complicated, they only ran two of the three cables. Getting the DPH42, hub and A/B switches setup will take some work. The cable ends just aren’t where they need to be.
