Bars not releasing
I have the Reese dual cam wdh setup. I have used this on a Jayco 23B and Jayco 28rls with no problems. When unhichting, I would raise the front of the trailer, unclip the saddles and drop down ...
Forum Discussion
genekiwi wrote:
snip..... do the bolt ends go on the inside or the outside? I put them on the inside but would turning them around make a difference?
If your referring to the Chain Hanger Bracket there is a correct way of attaching them to the Cam Arm...., improper placement will compromise the snap-up bracket function, and possibly increase related component wear.
Depending on the version of the Reese HP Dual Cam, the Chain Hanger Bracket design may very, note the different orientation of the Hanger Bracket assembly U-bolt threads when properly attached to the Cam Arm:
Latest HP version has a bend in the Hanger Bracket:
Earlier HP version Hanger Bracket is flat:
Hope this helps.
Bob
