Bent Hitch Pins
I recently bought a F250 Super Duty. I have been having bent hitch pins. The receiver that came from Ford is a 2 1/2 inch receiver that has a sleeve that reduces it down to a 2 inch. I have been to...
Forum Discussion
I also have a bent pin on my 13 ram 2500, with the 2.5 to 2" reducer sleeve. My entire set up is fairly new, truck, trailer, and equalizer hitch. My pin has not bent bad enough that I can't remove it, but there is a definate bend in it.
When assembled there is some slop in the sleeve and receiver.
The pin was aftermarket from the local rv dealer.
I am pulling a 30ft TH, approximately 9k.
When assembled there is some slop in the sleeve and receiver.
The pin was aftermarket from the local rv dealer.
I am pulling a 30ft TH, approximately 9k.
