Drill Bit Guide
I used to have a drill bit guide (not sure if this is the correct nomenclature), but it has gone missing. The guide had holes that you could place the bit to determine the size. I have 50-60 drill bit...
Forum Discussion
Vulcaneer wrote:Horizon170 wrote:usmohls2@yahoo.com wrote:
most all drill bits have the size stamped on them. Make your own with a small block of wood.
Right but the problem is if the drill ever slips in the chuck the size is then unreadable. :(
Then it ain't gunna fit in a drill index either.
If using the drill in a hand drill, then caliper measurement is close enough. The hole is going to be a few thousandths larger anyway. In a machining center then the hole will be a lot closer to the drill size.
Why won't it fit in a drill bit size gauge?
