How did I do this? - Bent Ball Mount
Hey Guys, My buddy showed me his cheap Harbor Freight load compensation hitch because he thought the ball was causing wear on his mount. I paused and said, the whole thing looks bent to ...
Forum Discussion
. My guess with bending down of the 2 5/16 " main ball mount and the left lean ( possible a also forward lean? ) of the left friction sway brake mini ball is that too sharp of a left jackknife turn bottomed out the left friction sway brake which would pull on the main ball, push on the mini ball. causing both to bend their mounts as shown.
From my welders and fabricators point of view, it is not a fault with the hitch, Maybe just too sharp of a turn, the sway brake rear mount set up too close on the tongue to allow fullslide action before ending its stroke.
This would cause one to bend down, the other up and sideways proportionally to the forces.
From my welders and fabricators point of view, it is not a fault with the hitch, Maybe just too sharp of a turn, the sway brake rear mount set up too close on the tongue to allow fullslide action before ending its stroke.
This would cause one to bend down, the other up and sideways proportionally to the forces.
