Forum Discussion

kokotg's avatar
kokotg
Explorer
Jan 05, 2017

Is installing a hitch receiver a reasonable DIY job?

We just bought a new toy hauler, and we're pushing up against the limits on tongue weight for our current hitch receiver, so we're planning to upgrade it. I found one that says no drilling required; b...
Hannibal's avatar
Hannibal
Explorer
Jan 08, 2017
I've installed a few. Not a bad job at all. The plug can be the biggest challenge if it's integrated into the OEM hitch receiver. The use of tie wraps helps with holding the new hitch up while bolts are started. Definitely use a torque wrench. You'd be surprised how much we all overtighten nuts and bolts without one.

About RV Tips & Tricks

Looking for advice before your next adventure? Look no further.25,102 PostsLatest Activity: Jan 18, 2025