Never Fail Bushings vs Wet Bolts?
I am planning on upgrading the suspension on our small fifth wheel this spring. Trailer is 5800# loaded, dual 3500# axles(2 3/8"). Springs, axles, brakes all seem fine. I am planning on installing a D...
Forum Discussion
Lynnmor wrote " If I were doing mine again, I would cut a figure 8 inside the bushings to allow grease to go all the way around. "
I did this with a 1/16" HSS ball-end cutter in a Dremel. Allows for an easy and proper greasing.
Art.
I did this with a 1/16" HSS ball-end cutter in a Dremel. Allows for an easy and proper greasing.
Art.
