Never Fail Bushings vs Wet Bolts?
I am planning on upgrading the suspension on our small fifth wheel this spring. Trailer is 5800# loaded, dual 3500# axles(2 3/8"). Springs, axles, brakes all seem fine. I am planning on installing a D...
Forum Discussion
Rvpapa wrote:
Lynnmor wrote " If I were doing mine again, I would cut a figure 8 inside the bushings to allow grease to go all the way around. "
I did this with a 1/16" HSS ball-end cutter in a Dremel. Allows for an easy and proper greasing.
Art.
Can you guys expand on this a bit? I understand the advantage to cutting passages for the grease to get all around the bushing, but how do you get any kind of cutting tool inside the ID of the bushing?
