New to Dinghy Towing

Thanks Heisenberg -

Trop - I thought of that but was concerned about it falling and causing real damage as it might get wedged between under carriage and road... not sure but maybe I can install a hook to the floor where it is bolted and couldn't slip backward to fall out of trans - thanks

t36 ... It can be done on a GMC pickup. I do not know about the clearances on the Grand Cherokee. I cinched mine up tight to make sure I didn't lose it. After replacing the seal I wondered if the cinch job stressed the seal causing the leak.

ANewTraveler wrote:
Do I have to worry about the trans fluid leaking out when I pull the yoke out of trans?

Can't you just tie the shaft up underneath somewhere. Maybe make a sling of sorts for it?

ANT ... I do not think so, mine was a GMC. However you will need to keep it clean on both ends. The output seal on my pickup began to leak after a couple of years. It was an easy fix but I began covering the opening with a rag and wiping the spline before inserting the driveline.

Do I have to worry about the trans fluid leaking out when I pull the yoke out of trans?

ANT ... You need to take a punch and mark the shaft joint and rear end joint before removal so that you put them back the same each time. You risk an unbalanced shaft if you put the joints back 180 degrees out. You will get tired of removing the shaft and will be in the market for a remco pump or a different vehicle. Have fun!

I have a rear 2 wheel drive on my 2004 jeep grand Cherokee - I was told that I could pull the drive shaft off the back near differential and pull from trans to carry it and put back on when destination reached, As far as anyone knows - is that true? anything I need to watch for ( other than the little work involved in removing and installing the shaft?

You can go HERE and get a good estimate for everything you need. Again, you will be looking at (1) Base Plate, (2) Tow Bar, (3) Light system, and (4) Brake system.

There are not only other manufactures of these products but also many dealers that have lower prices than the manufactures do. If you are up to "used" products, you can also check out eBay and Craigslist.

Hope this helps

Ron

Be sure to check the "Recreational Towing" section of your manual to make sure the drive train you have can be towed 4-down.

Just a reminder from Jeep.

"Only vehicles equipped with the Quadra-Trac II/ Quadra-Drive II systems can be towed four wheels down."