No water coming out of the faucets
Need help with my new to me RV. With water supply hooked up to the RV and turned on, water comes out of all of the faucets. When I turn off the water supply and try to run off of the tank no water...
Forum Discussion
Could be a lot of reasons why. Here is what I would do.
1. Look at your pump.
2. See what brand and model you have.
3. Get on-line.
4. Google it.
4. At end of instructions will usually have trouble shooting guide.
Example...here is mine, page 3 has info (your might be different)
http://www.manualslib.com/manual/762753/Pentair-Shurflo-4008-Rv-Revolution.html?page=3#manual
TROUBLESHOOTING Vibration induced by driving can loosen plumbing, strainers and pump hard- ware. Check for system components that are loose. Also, refer to the chart below for trouble-shooting tips.
PUMP WILL NOT START/ BLOWS CIRCUIT ? Electrical connections, fuse or breaker, main switch, and ground connection. ? Is the motor hot? Thermal breaker may have triggered; it will reset when cool. ? Is voltage present at the switch? Bypass pressure sw. Does the pump operate? ? Charging System for correct voltage (±10%) and good ground. ? For an open or grounded circuit, or motor; or improperly sized wire. ? For seized or locked diaphragm as- sembly (water frozen?).
WILL NOT PRIME/SPUTTERS (No discharge/Motor runs) ? Is the strainer clogged with debris? ? Is there water in the tank, or has air collected in the hot water heater? ? Is the inlet tubing/plumbing suck- ing in air at plumbing connections (vacuum leak)? ? Is inlet/outlet plumbing severely restricted or kinked? Restrictive valves? ? Proper voltage with the pump oper- ating (±10%). ? For debris in pump inlet/outlet valves or swollen/dry valves. ? Pump housing for cracks or loose drive assembly screws
1. Look at your pump.
2. See what brand and model you have.
3. Get on-line.
4. Google it.
4. At end of instructions will usually have trouble shooting guide.
Example...here is mine, page 3 has info (your might be different)
http://www.manualslib.com/manual/762753/Pentair-Shurflo-4008-Rv-Revolution.html?page=3#manual
TROUBLESHOOTING Vibration induced by driving can loosen plumbing, strainers and pump hard- ware. Check for system components that are loose. Also, refer to the chart below for trouble-shooting tips.
PUMP WILL NOT START/ BLOWS CIRCUIT ? Electrical connections, fuse or breaker, main switch, and ground connection. ? Is the motor hot? Thermal breaker may have triggered; it will reset when cool. ? Is voltage present at the switch? Bypass pressure sw. Does the pump operate? ? Charging System for correct voltage (±10%) and good ground. ? For an open or grounded circuit, or motor; or improperly sized wire. ? For seized or locked diaphragm as- sembly (water frozen?).
WILL NOT PRIME/SPUTTERS (No discharge/Motor runs) ? Is the strainer clogged with debris? ? Is there water in the tank, or has air collected in the hot water heater? ? Is the inlet tubing/plumbing suck- ing in air at plumbing connections (vacuum leak)? ? Is inlet/outlet plumbing severely restricted or kinked? Restrictive valves? ? Proper voltage with the pump oper- ating (±10%). ? For debris in pump inlet/outlet valves or swollen/dry valves. ? Pump housing for cracks or loose drive assembly screws
