Quick Release Drive Shaft
Has anyone used the quick release drive shaft while towing on all fours? I've seen different advertisements relating to the quick releases but I haven't seen any feedback on them. Thanks.:?
Forum Discussion
MCDDY wrote:
When we bought our 98 Blazer new, installed a Remco driveshaft disconnect within the 1st month. Still on the car which is my daily driver. Only one balance problem when new but a driveshaft shop cured that quickly. Lube it a couple of times a yr.. I'd bet that most of the horror stories are from an improper install and not following the written instructions on operation.
Dave
well my unit was installed by a drive shaft shop that was very experienced in the installation which is why I drove about 100 miles to get it done. and which written instruction made mine clatter when attempting to mesh the gears. IIRC the instruction was to turn off engine and when the gear was almost stopped, to mesh the gears.
bumpy
