towing with my new Hensley arrow...
Sooo, I got my hitch installed. I'll post pics later... get my truck hooked up. set up the WD ( I got the chains and snap up brackets) I wish all brackets were like these... the chains are held ...
Forum Discussion
bigcitypopo wrote:
Great Pic!! quick question tho..
Did you roll the trialer tires on to 2x6 or 8's and the tongue as well. Just wondering if you snow shoe'd those tires to help with "sinking"? did you shoe your truck on the hook up?
Nope...all tires at 15 psi, both truck and trailer, and rolling on the sand. Under the tongue jack I block it up as normal, but add a 12x24 piece of 3/4" plywood underneath the cribbing to keep the whole mess from sinking in the sand.
Bear in mind it's a about a 2 mile drive through the sand to get to the site in the picture, not gonna do that on 2x8's.
Point is that 99% of the time you re-hitch the same as you un-hitched. If something changes, like you unhitched at an angle are re-hitching straight, you can use the screw jacks to adjust that stinger box to any angle up/down or side/side and hold it there.
