WD Setup
Traded TV so setting up the hitch again, I have it setup so the unhitched and hitched with WD come out to the same wheel well measurements. The original owner of this trailer just used a standard ball...
Forum Discussion
Hornnumb2 wrote:Are you saying that both the front and rear wheel wells were returned to their original heights after application of WD? If so, that would be an unusual result because it would mean neither the front nor the rear axle is carrying any tongue weight.
Traded TV so setting up the hitch again, I have it setup so the unhitched and hitched with WD come out to the same wheel well measurements. --- Should it have some weight on the rear of the truck or should it be ok like it is? ---
If you return the front axle to the unhitched height, per the manual, you will remove about 45% of the load which was added to the rear axle. So, even if the front is returned to unhitched height, the rear will have a noticeable amount of sag.
Ron
