10/3 Wire split
Hello friends, I have a 10/3 wire (my 30amp service line) from the inlet to the breaker box and between the two I have a cut in the insulation. I'm wanting to splice the wire and put in a new piec...
Forum Discussion
Which description? It is the factory wire that runs from the back of the inlet (drivers side) across the back of the RV (inside) then down through the floor for about 12ft only to come back up from under the floor to the power box.
I just see it as a "pain" to replace since I'll have to pull the bottom of the RV apart to get to the wire if I was to replace it. If I have to cut it then I was hoping to just put it in a junction box and wire it up normally with wire nuts but I don't have experience with 10 gauge wire and concerned if cutting the wire would cause it to get hot at the wire nuts.
I'm not having any problems with it as it is but like another poster said, "It is ugly" :)
I just see it as a "pain" to replace since I'll have to pull the bottom of the RV apart to get to the wire if I was to replace it. If I have to cut it then I was hoping to just put it in a junction box and wire it up normally with wire nuts but I don't have experience with 10 gauge wire and concerned if cutting the wire would cause it to get hot at the wire nuts.
I'm not having any problems with it as it is but like another poster said, "It is ugly" :)
rhagfo wrote:icodeintx wrote:
Oh my... I was hoping not to hear "replace" :(
That wire goes under the floor, under the door and through the kitchen to the power box.
That description scares me worst than the picture!!!
