8531 /Burner Issue UPDATE--Photos ( Fixed!)
With the furnace running, where do you put the pos and neg leads of the meter? Or can you do it at the Tstat inside with the furnace on? I want the 12v to the board, not the voltages the board puts...
Forum Discussion
Did the clean ups, bent the three prongs down a bit, got it all back together, and now all I get is the fan and some clicks, smell gas, no flame.
Pulled it out with no gas line, all wires connected and turned on Tstat, still runs with fan and then clicks, but no spark seen on the sparker ends.
Tried my other boards I thought were not working right before and same thing. The board that was working till today (except for the cutting in and out business) was at least getting the burner to light after the click. Not now.
That "rusty" plate the prongs are on is actually copper that shines up so it is not as bad as it looks in the photo.
No idea what to try next!
Maybe I should get that three-prong part from Amazon since it is not costly. I could get a new board but I am not convinced that is the problem yet.
Pulled it out with no gas line, all wires connected and turned on Tstat, still runs with fan and then clicks, but no spark seen on the sparker ends.
Tried my other boards I thought were not working right before and same thing. The board that was working till today (except for the cutting in and out business) was at least getting the burner to light after the click. Not now.
That "rusty" plate the prongs are on is actually copper that shines up so it is not as bad as it looks in the photo.
No idea what to try next!
Maybe I should get that three-prong part from Amazon since it is not costly. I could get a new board but I am not convinced that is the problem yet.
